I just installed our new Frontier carseat in my 2005 Subaru Outback wagon. I have installed many carseats before and this one was the trickiest, but by no means insurmountable. The short path install didn't work, it was way too loose. So I tried the long path after reading the Amazon reviews and their tips. One person mentioned using a spring clamp to hold the seat belt while you do the routing. Voila! That is the trick, especially when you are installing solo. I pulled the seatbelt all the way out and placed the spring clamp on the shoulder belt right where it enters the vehicle, so it can't retract at all. That gives you all the working room you need to route the belt properly, buckle it and then start tightening. Using your knees to push the seat into the car as far as possible, work backwards, tightening the lap belt, then pulling the slack into the shoulder belt until you get to the spring clamp at the top of the shoulder belt. Pull it as tight as possible - my seat doesn't move a fraction of an inch - it's going no where. I love it! The Pink Sky is very chic and my 4-year old loves it. After installation, take a shower because you'll be sweating....Get more detail about Britax Frontier Booster Car Seat Rushmore.
No comments:
Post a Comment